125cc Sportsbikes Forum banner
1 - 20 of 25 Posts

·
Registered
Joined
·
627 Posts
yea im havin the same problem m8, was gonna take mine off and paint em but gave up after 5 mins.
 

·
Registered
Joined
·
627 Posts
im just trying to get the end off, theres a screw in the end but you can turn it either way and it doesnt undo, cant get enough grip on the bar end to hold it and turn the screw either.
 

·
Registered
Joined
·
627 Posts
OMG OMG!!!1!LOLZ OMG LOLZ!!!111elevenshift+1

cheers.im gonna go try that now
 
G

·
those clips r brocken now
Hey

Look at Mr Muscles,
nice bar ends! exactly what I was gonna get but was told that they wont fit, so got some crappy red ones for a cbr600, haven't tried them yet as I aint got the strength to get the old ones off.

Are they the Motorax bar ends?
 

·
Registered
Joined
·
6,817 Posts
bar ends are a b*st*rd to get off.

try soaking them with wd-40 before you try to remove them. just drench them. leave em for a few minutes.

then try....
 

·
Registered
Joined
·
517 Posts
Discussion Starter · #14 ·

·
Registered
Joined
·
205 Posts
Sweet just after getting them off! Just drowned them in wd40 there now so i can attempt to get the screw off later! Noticed there was a sh*t load of glue where the end meets the weight so tried to scrape as much of that off as well!
 
1 - 20 of 25 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top