125cc Sportsbikes Forum banner
1 - 20 of 407 Posts

·
Cagiva Geek :)
Joined
·
10,333 Posts
Discussion Starter · #4 ·
hahahhaha


just took couple of pics, but carb float needl is fooked so need some new bits then it'll be rite
bike did run and is fast just runs out of fuel cos needle is fooked



GIANELLI FTW!







still loads to do. clean it as he used it offroad, its all going back to standard as i have everything to make it standard ( bodywork wise )

cant wait to get it goin properly he he he
 

·
CBR125 Section SuperMod!
Joined
·
6,698 Posts


that was the dogs need doing like that again imo then let me loose on the beast
 

·
Registered
Joined
·
2,881 Posts
...
i bet cagiva geezer is having a right old pokey bum wank over the gianellis
Hi !

2nd that. id do the same thingy


Once i had an opportunity to buy a new Giannelli Silencer Kit (only silnecer's) from ebay.it but i didnt use it. Blody shame that the seller didnt have the Zaust...

bye !
markus
 

·
Cagiva Geek :)
Joined
·
10,333 Posts
Discussion Starter · #15 ·
so p**sed off. just took top end off because i looked up exhaust port and there was nasty piston damage.
cylinder has a tiny spot of damage when i say tiny i mean tiny.
Think i may just get away with new piston and see how it goes, use a bit wet and dry on cylinder and go from there. bike ran fine with this piston / cylinder so guessing it aint too bad.
top ends off now, will order new piston n gaskets now lol.
OH well.............

col
 
1 - 20 of 407 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top